Before Turning On The Scroll Saw
1. Always wear safety glasses when operating any machinery. 2. Do not cut plaster, metal, etc... on the scroll saw. Only wood, wood composites, and plastic should be cut on scroll saw. 3. Make any adjustments while power is off. 4. Check blade for any damage. 5. Make sure the blade on the machine is the proper type for the cut you are planning. Thin blades for curves and corners, wide blades for long straight cuts. If you have any questions or need to change the blade ask your instructor. 6. Always adjust guard so that it touches stock during the cut. Operating The Scroll Saw 1. Keep stock clear of blade turn on scroll saw then feed stock through. 2. Plan cut to maximize forward cutting and minimize backing of the blade during cutting. 3. While cutting, feed material at a slow to moderate speed. Do not push material through, guide material while blade does its work. 4. Always keep fingers out of the path of the cut and a minimum of 2 inches from the blade. 5. Only cut flat stock. If you need to cut round or irregular shaped stock ask your instructor for assistance. 6. Allow machine to come to a complete stop before backing out of cut. 7. If blade breaks or comes off, back away and shut off power to scroll saw. 8. Keep area clean. Use a brush to remove chips and shavings after blade has come to a complete stop. |