Before Turning On The Jointer
1. Always wear safety glasses when operating any machinery. 2. Make cut depth adjustments before turning on jointer. **Limit depth of cut to 1/8 inch** 3. Use only clean lumber. Lumber with nails, loose knots, paint, etc should not be surfaced on the jointer. Operating The Jointer 1. Use push blocks whenever possible to avoid injury. Always keep fingers at least 2 inches away from blade. 2. Keep stock securely against fence. 3. Keep area inline with jointer clear while in operation to avoid possible injury if stock is ejected from machine. 4. Make sure there is adequate clearance for stock as it feeds through jointer. 5. Make sure guard over blades returns after cut. Do not tamper with or remove guard. 6. Push stock over blades and allow guard to close before attempting to remove stock. 7. Stock to be face cut should not be less than 1/2 inch thick. Stock to be edge jointed should not be less than 1/2 inch thick, 3 inches wide, and 12 inches long. 8. Never put pressure on stock directly over the knives. 9. Be sure the guard returns properly over the knives and never remove the guard. |